Action Construction, Inc. company logo

Sump Pump Installation and Repair in White Plains, NY

Sump pump installation and repair to help keep White Plains, NY basements dry.

Down in a basement, the sump pump is the machine in the pit at the lowest point that sends groundwater and stormwater away from the foundation. A well pump is something else, part of a private drinking water supply. Action Construction installs, replaces, and repairs sump pumps for White Plains, NY homes, with battery and water powered backup systems for the storm related power outages when a pump is needed most. Well pump service is not part of this work.

Sump pump and well pump are different systems

Sump pump and well pump are easy to mix up. The sump pump sits in a pit at the low point of the floor as a basement flood control device, removing groundwater and stormwater that gather there and sending it outside. A well pump is different: it belongs to a private drinking water system and draws potable water up from the well into the building. Municipal water supplies most of White Plains, though a few outlying Westchester properties we also serve still depend on a private well. The system covered on this page is the sump pump, not the well.

Warning signs from your sump pump

Here is how to tell your sump pump is on its way out. Watch for a discharge line outside that is frozen or has come loose, constant running, or cycling on and off about once a minute. Humming with no water moving is another sign, along with a float switch that sticks so the pump will not start or will not stop, rust or corrosion on the body, and a check valve that allows water to drop back into the pit after each cycle. Standing water in the pit above the normal shutoff level counts too. A pump older than 7 to 10 years that shows any of this ought to be swapped out ahead of the next heavy storm and not during it.

Short cycling, when the pump starts and stops over and over, is reason enough to call. A pit that is too small, a check valve that has failed, or a float that is set wrong is usually behind it, and each one wears the motor out fast. If the pit has already overflowed and flooded the basement, it is an emergency plumbing repair.

Installation, replacement, and repair explained

For a new installation, the pit is cut at the lowest point of the slab, a basin is set in gravel, and a submersible or pedestal pump goes in with a quiet check valve, with the discharge line running to daylight or a storm drain at a good distance from the building. Pump size follows the incoming water, since the right size keeps the pump from running itself to death: a third horsepower is typical for a home, while a half horsepower is for a high water table or a long lift to the discharge point.

A replacement puts in a new pump, matched to the pit, the float type, and the water volume, in place of one that failed or wore out. A repair deals with a stuck float switch, a clogged intake, a failed check valve, an air lock in the impeller, or a frozen or disconnected discharge line. Whichever of the three you need, the written price comes first.

How water gets into White Plains basements

The reasons come down to terrain and older housing, and roof water is a common one. On many older homes the downspouts were never extended away from the wall, so rain from the roof ends up against the foundation and looks for a way in. The basement itself is the other half of the problem, because the older single family neighborhoods around downtown often have basements built without a perimeter footing drain, which leaves groundwater only one way out, upward through the slab and the cove joint where the floor meets the wall. A finished space also needs a sealed lid with a gasketed cable pass through on the pit, since an open pit lets radon and soil gas in.

A full general contractor can fix the cause, not just pump out the effect. Regrading the first few feet of soil to slope away from the building, running downspouts out through buried extensions, and adding a footing drain inside or outside that feeds the pit are all options. If water comes in as a steady seep at one spot, not as a rising table, start with a leak detection visit to rule out a buried supply line, then see the White Plains plumbing services hub for the full range.

Battery and water powered backups, and what the price includes

A power outage during a storm is when a sump pump matters most, which is why we advise a backup, either a battery backup pump or a water powered one, for finished basements and for any property where a failure means real damage. The battery type has a sealed battery feeding a DC pump that starts if the primary loses power or cannot keep pace. The water powered type needs no battery and runs on pressure from the municipal supply, which uses some potable water as it works.

$A replacement pump set into an existing pitfalls at the low end of the range.
$ $A full new installation, where the slab has to be broken and a fresh discharge line run, costs more.
Routing the discharge so that it does not dump back against the foundation or across a neighbor’s lot is part of what the written price buys, along with the pump, the check valve, and any backup you choose.

Frequently Asked Questions: Sump Pump Installation and Repair in White Plains, NY

How much does it cost to put in a sump pump in White Plains?

A new sump pump install is priced by scope, and the cheapest case is a replacement pump dropped into an existing pit. Cutting the slab, installing a basin, and routing a new discharge line push the number up. A battery or water powered backup raises it again, which a finished basement justifies. You get the full written quote ahead of the work.

How is a sump pump different from a well pump?

We service sump pumps, and they do a different job from a well pump. A sump pump pushes groundwater from under or beside the basement back outside. A well pump supplies drinking water from a private well. The two systems are separate.

What is the lifespan of a sump pump?

A sump pump typically gives 7 to 10 years of service. Pumps that cycle nonstop because of a high water table, a basin that is too small, or a check valve that has failed tend to give out sooner. Replacing an aging unit ahead of a big storm beats doing it afterward, because those storms often cut the power too.

Does a sump pump prevent basement flooding?

A well sized pump that is maintained and has a working backup keeps up with typical groundwater and storm seepage. It will not fix a foundation drain that has failed or grading that points water at the house. We are a full general contractor, so we can correct those underlying causes rather than just removing the water.

Is a battery backup for a sump pump necessary?

Yes, when the basement is finished or holds things you would hate to lose. A pump with no backup is at risk during the worst storms, since those are the same storms that interrupt power, which leaves it dead when water is rising.

Ready to Start Your Plumbing Project in White Plains?

Need commercial construction, renovations, or plumbing services? Tell us about the project and we will set up a consultation and estimate.

Licensed & Insured | Residential & Commercial | Serving CT & NY